| Corn | Soybeans |
| Small Grains | |
| Peas | Sweet Corn |
U-TROUGH APPROACHQuenchAg is produced by combining nitrogen, phosphate and potassium. QuenchAg can be used on most field crops, vegetables, fruit and nut trees and more. Since it contains 100% orthophosphate, which is immediately available to the seeding or plant.
QuenchAg may be used, in small amounts, as a starter fertilizer. QuenchAg has a pH of 7, making it as safe as water and effective as a foliar spray. QuenchAg can also be applied through drip irrigation systems. To insure best performance, use QuenchAg when there is adequate humidity, moderate temperatures and adequate soil moisture. Foliar sprays should be made during the early morning and late evening hours.
MIXING INSTRUCTIONS
QuenchAg mixes completely in water with minimal agitation.
- Fill tank roughly ½ full of water and begin agitation.
- Add QuenchAg to mix tank.
- Add other pesticides and/or nutrients (be sure to check compatibility prior to mixing)
ATTENTION: Always check compatibility with other products prior to use. QuenchAg is not compatible with products containing calcium.
SOIL APPLICATION RATES
Vegetables: For sprinkler irrigated fields, spray or dribble directly over the seed at planting. For furrow irrigated fields, inject directly below the seed row 1-2". Use 2-5 gallons/acre. QuenchAg may be diluted with water if desired.
Corn, Cotton, Melons: Inject ½ - 2" directly below and/or to the side of the seed furrow. Use 3-10 gallons/acre. QuenchAg may be diluted with water if desired.
Vegetable, Field Crops, Fruits, Fruit and Nut Trees: Apply 1-3 gallons of QuenchAg in at least 5 gallons of water/acre. Multiple applications may be useful. Use of Chameleon (nonionic spreader/sticker) may enhance coverage and increase plant uptake. Do not apply more than 3 times per growing season. Do not apply when the crop is under severe stress. For best results, use the lowest possible volume that will ensure complete coverage and small droplet size.
Drip Irrigation (All Crops): Use 3-I20 gallons of QuenchAg per irrigation. Continue irrigation for at least 2 hours to insure adequate fertilizer coverage.
Transplant Water (All Crops): Use 1-4 gallons of QuenchAg per acre in 500-1000 gallons of water per acre.
| GUARANTEED ANALYSIS: | |
| Total Nitrogen (N) | 9.00% |
| Available Phosphorus (P2O5) | 18.00% |
| Soluble Potash (K2O) | 9.00% |
Derived from: Phosphoric Acid, Potassium Hydroxide, Aqua Ammonia, Urea, Polysaccharides and Organic Salts, Surfactants, Humic and Fulvic Acids.
